MAGSY.cz

This type of magnetic separator is intended for trapping metallic magnetic particles in a stream of mainly liquid substances. It is fitted with very strong permanent magnets, in order to prevent carrying magnetic particles away by a stream of liquid. These are neodymium-NdFeB magnets that have several times higher magnetic induction (magnetic force) when compared with standard ferrite magnets which would not be able to hold metallic particles from liquid.

As a standard, we produce separators with the input and output diameters of 50, 100, 150 (left pic.) and 250 mm (250 mm only in the modification with automatic cleaning). Magnetic separators can be also delivered in a two-shell design for internal shell heating (e.g. separation from chocolate).

This type of magnetic separator has been designed so as the operator need not to remove magnetic cores from stainless steel non-magnetic bushes when cleaning which prevents in their contamination or damage. When cleaning is being performed, the magnetic cores remain in the uncovered upper part of the magnetic component. The body of the magnetic separator is provided with a discharging hole to allow discharge of residual heat and liquid before it is cleanined.

NEWS - Introducing a new type of magnetic separator MF 50 / 1 - read more

After unlocking suspension bolts (on diameters of 50 and 100 these are cap nuts), remove the magnetic component from the magnetic separator body, unlock the locking clamp and - using a handle - pull out the magnets into the upper position. This will result in de-magnetizing of the stainless steel tubes and metallic particles will drop away.

For more information, please, do not hesitate to contact us at any time.

As for cooling and de-greasing emulsion separation, we offer a specifically-designed magnetic grate the development of which was intended on its resistance against humidity - the magnets are covered so the contact with liquid will never take place. The great advantage of this system also consists in the fact that the magnets never attach at any place during cleaning so there is no risk of injury. The separator is fitted with very strong neodymium magnets.

Magnetic rods with the diameters 25 and 30 mm are fitted with very strong neodymium NdFeB magnets. Due to reaching a very thin covering pipe wall, the resulting magnetic force on the magnetic pipe surface is 6 000 Gs for the diameter 25 mm and 7 000 Gs for the diameter 30 mm! Using these magnetic rods, you may put together any magnetic separator by yourselves.

Using the thread, screw the magnetic rods on an arbitrary carrier, making thus a simple magnetic grate. As an improved version, you may place the magnetic rods into stainless steel pipes - this is by reason of their cleaning. After being subsequently pulled out, metals will fall off - however, magnetic force becomes reduced significantly.

You may buy the magnetic rods directly here.